Stepped clamps for rotary table
#3
I found the contact info and sent an e- mail asking for more info on the clamps. I hope someone there can read English.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Stepped clamps for rotary table - by chucketn - 08-24-2014, 08:28 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 09:31 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 10:18 AM
RE: Stepped clamps for rotary table - by EdK - 08-24-2014, 10:59 AM
RE: Stepped clamps for rotary table - by TomG - 08-24-2014, 01:21 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 11:03 AM
RE: Stepped clamps for rotary table - by chucketn - 08-25-2014, 11:10 AM
RE: Stepped clamps for rotary table - by TomG - 08-25-2014, 01:24 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 04:26 PM
RE: Stepped clamps for rotary table - by EdK - 08-26-2014, 07:52 AM
RE: Stepped clamps for rotary table - by Arbalest - 08-26-2014, 07:38 AM
RE: Stepped clamps for rotary table - by TomG - 08-26-2014, 08:24 AM
RE: Stepped clamps for rotary table - by DaveH - 08-26-2014, 12:00 PM



Users browsing this thread: 4 Guest(s)