Stepped clamps for rotary table
#2
I found the website I got the idea from, but it's in German, and I don't read or write German. I'm not that good in my native 'Merican English...

It's here"

http://www.metallmodellbau.de/GEAR-CUTTING.php

No link or indication to translate the web page or corespond in english with the author of the article. I can see the clamp I'm talking about in several views, so I'll just measure up my RT and see if I can make something like it!

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Stepped clamps for rotary table - by chucketn - 08-24-2014, 08:28 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 09:31 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 10:18 AM
RE: Stepped clamps for rotary table - by EdK - 08-24-2014, 10:59 AM
RE: Stepped clamps for rotary table - by TomG - 08-24-2014, 01:21 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 11:03 AM
RE: Stepped clamps for rotary table - by chucketn - 08-25-2014, 11:10 AM
RE: Stepped clamps for rotary table - by TomG - 08-25-2014, 01:24 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 04:26 PM
RE: Stepped clamps for rotary table - by EdK - 08-26-2014, 07:52 AM
RE: Stepped clamps for rotary table - by Arbalest - 08-26-2014, 07:38 AM
RE: Stepped clamps for rotary table - by TomG - 08-26-2014, 08:24 AM
RE: Stepped clamps for rotary table - by DaveH - 08-26-2014, 12:00 PM



Users browsing this thread: 1 Guest(s)