The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




Stepped clamps for rotary table
#1
I am setting up to cut gears using a 4” Vertex Rotary Table on my X2 Mill. Somewhere, in my research, I saw a picture of the same RT, clamped to a mill table using custom low profile clamps that nearly filled the slots on the Vertex and didn’t interfere with either the RT table or the chuck that was mounted. I didn’t think at the time to save the picture or ask the poster about it. Now I can’t find it.
The clamps did not require the use of the standard clamping kit step blocks. They looked like an upside down stair case.
Anyone know where this design came from? Can I get a reference or even a sketch of the dimensions, please?
Thanks,
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Stepped clamps for rotary table - by chucketn - 08-24-2014, 08:28 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 09:31 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 10:18 AM
RE: Stepped clamps for rotary table - by EdK - 08-24-2014, 10:59 AM
RE: Stepped clamps for rotary table - by TomG - 08-24-2014, 01:21 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 11:03 AM
RE: Stepped clamps for rotary table - by chucketn - 08-25-2014, 11:10 AM
RE: Stepped clamps for rotary table - by TomG - 08-25-2014, 01:24 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 04:26 PM
RE: Stepped clamps for rotary table - by EdK - 08-26-2014, 07:52 AM
RE: Stepped clamps for rotary table - by Arbalest - 08-26-2014, 07:38 AM
RE: Stepped clamps for rotary table - by TomG - 08-26-2014, 08:24 AM
RE: Stepped clamps for rotary table - by DaveH - 08-26-2014, 12:00 PM



Users browsing this thread: 1 Guest(s)