This is the trunnion clamp I cannot get and need to make.
![[Image: hlDTD1LJJ-fpxrfX6eNQOZxtikatsTssmWuZI-2CswI=s250-no]](https://lh6.googleusercontent.com/hlDTD1LJJ-fpxrfX6eNQOZxtikatsTssmWuZI-2CswI=s250-no)
Two thoughts come to mind:
1) Make it in single pieces on the mill, get a boring head and/or a dovetail cutter and do it on the rotary table.
2) Get a disk, mount it on a faceplate and to the lathe, cut the profile and then get a few pieces out of it and sell some to recover costs.
I know I am being vague about the two methods, it's just that I have not figured it out yet.
Two thoughts come to mind:
1) Make it in single pieces on the mill, get a boring head and/or a dovetail cutter and do it on the rotary table.
2) Get a disk, mount it on a faceplate and to the lathe, cut the profile and then get a few pieces out of it and sell some to recover costs.
I know I am being vague about the two methods, it's just that I have not figured it out yet.