MetalworkingFun Forum › Machining › Projects v
Toolpost lock nut

Thread Modes
Toolpost lock nut
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#6
08-20-2014, 06:30 AM
I don't see the advantage of the thrust washers. It seems you would have just as much force, but easier to move as the bearing gives up "grip".

Educate me please. I suck at physics.
Reply
Thanks given by:


Messages In This Thread
Toolpost lock nut - by schor - 08-19-2014, 05:32 PM
RE: Toolpost lock nut - by PixMan - 08-19-2014, 09:55 PM
RE: Toolpost lock nut - by schor - 08-19-2014, 10:39 PM
RE: Toolpost lock nut - by DaveH - 08-19-2014, 11:12 PM
RE: Toolpost lock nut - by schor - 08-19-2014, 11:51 PM
RE: Toolpost lock nut - by PixMan - 08-20-2014, 06:30 AM
RE: Toolpost lock nut - by stevec - 08-20-2014, 09:17 AM
RE: Toolpost lock nut - by Mayhem - 08-20-2014, 07:37 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 09:23 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 09:30 AM
RE: Toolpost lock nut - by stevec - 08-20-2014, 11:09 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 11:33 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 12:06 PM
RE: Toolpost lock nut - by DanH - 06-28-2015, 02:03 PM
RE: Toolpost lock nut - by the penguin - 06-28-2015, 05:26 PM
RE: Toolpost lock nut - by Hopefuldave - 06-28-2015, 06:27 PM
RE: Toolpost lock nut - by donray0 - 07-09-2015, 09:27 AM
RE: Toolpost lock nut - by EdK - 07-09-2015, 04:27 PM



Users browsing this thread: 3 Guest(s)