MetalworkingFun Forum › Machining › General Metalworking Discussion v
Free!

Thread Modes
Free!
pineyfolks Offline
Freshman
**
Posts: 10
Threads: 1
Joined: Aug 2013
Location: Dillonvale
#11
08-18-2014, 02:53 PM
Good score Tom. It's amazing what a company throws away. I once got a L&W chuck dividing head with the plates. The engineer said he'd never seen it used on the lathe. I told him it was a milling attachment. He said if you can use it, it's yours.
pineyfolks, proud to be a member of MetalworkingFun Forum since Aug 2013.
Reply
Thanks given by:


Messages In This Thread
Free! - by TomG - 08-17-2014, 07:51 PM
RE: Free! - by EdK - 08-17-2014, 08:04 PM
RE: Free! - by TomG - 08-17-2014, 08:11 PM
RE: Free! - by Shawn - 08-17-2014, 08:19 PM
RE: Free! - by TomG - 08-17-2014, 08:40 PM
RE: Free! - by DaveH - 08-18-2014, 07:41 AM
RE: Free! - by Mayhem - 08-18-2014, 08:14 AM
RE: Free! - by PixMan - 08-18-2014, 09:19 AM
RE: Free! - by TomG - 08-18-2014, 11:27 AM
RE: Free! - by the artfull-codger - 08-18-2014, 02:17 PM
RE: Free! - by pineyfolks - 08-18-2014, 02:53 PM
RE: Free! - by TomG - 08-18-2014, 04:40 PM
RE: Free! - by stevec - 08-18-2014, 06:01 PM
RE: Free! - by Dr Stan - 09-13-2014, 04:49 PM
RE: Free! - by krv3000 - 08-18-2014, 04:28 PM
RE: Free! - by TomG - 09-13-2014, 07:23 PM



Users browsing this thread: 1 Guest(s)