|
Glanze Boring Bar
|
08-17-2014, 07:05 PM
to start with set it up on the center line take a few passes thru a part, depending on the insert that you have on the bar will determine if you need it a above or below the center line.
what type insert is on the bar. DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Glanze Boring Bar - by Will_D - 08-17-2014, 01:44 PM
RE: Glanze Boring Bar - by dallen - 08-17-2014, 02:53 PM
RE: Glanze Boring Bar - by Will_D - 08-17-2014, 03:34 PM
RE: Glanze Boring Bar - by Will_D - 08-17-2014, 06:27 PM
RE: Glanze Boring Bar - by dallen - 08-17-2014, 05:41 PM
RE: Glanze Boring Bar - by Mayhem - 08-17-2014, 05:57 PM
RE: Glanze Boring Bar - by dallen - 08-17-2014, 07:05 PM
RE: Glanze Boring Bar - by PixMan - 08-18-2014, 06:29 AM
RE: Glanze Boring Bar - by Will_D - 08-18-2014, 05:47 PM
RE: Glanze Boring Bar - by Mayhem - 08-19-2014, 06:08 AM
|
