05-07-2012, 03:03 PM
Hi
This is my rough and ready draw bar tool
I used copper for the hammer bit
As you can see it is of welded construction
![[Image: P5070053.jpg]](http://i261.photobucket.com/albums/ii63/john970s0/P5070053.jpg)
The draw bar is simply a piece of 7/16 unf studding the brass bush makes tightening a bit smoother
The handle is only 6 inches long a good one handed nip is all that is needed
The mill is a Chester 626 with a R8 spindle
![[Image: P5070055.jpg]](http://i261.photobucket.com/albums/ii63/john970s0/P5070055.jpg)
![[Image: P5070057.jpg]](http://i261.photobucket.com/albums/ii63/john970s0/P5070057.jpg)
John
This is my rough and ready draw bar tool
I used copper for the hammer bit
As you can see it is of welded construction
The draw bar is simply a piece of 7/16 unf studding the brass bush makes tightening a bit smoother
The handle is only 6 inches long a good one handed nip is all that is needed
The mill is a Chester 626 with a R8 spindle
John