MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Glanze Boring Bar

Thread Modes
Glanze Boring Bar
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#2
08-17-2014, 02:53 PM
you got it right, if you look at it from the end the cutting edge should be on the center line.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Glanze Boring Bar - by Will_D - 08-17-2014, 01:44 PM
RE: Glanze Boring Bar - by dallen - 08-17-2014, 02:53 PM
RE: Glanze Boring Bar - by Will_D - 08-17-2014, 03:34 PM
RE: Glanze Boring Bar - by Will_D - 08-17-2014, 06:27 PM
RE: Glanze Boring Bar - by dallen - 08-17-2014, 05:41 PM
RE: Glanze Boring Bar - by Mayhem - 08-17-2014, 05:57 PM
RE: Glanze Boring Bar - by dallen - 08-17-2014, 07:05 PM
RE: Glanze Boring Bar - by PixMan - 08-18-2014, 06:29 AM
RE: Glanze Boring Bar - by Will_D - 08-18-2014, 05:47 PM
RE: Glanze Boring Bar - by Mayhem - 08-19-2014, 06:08 AM



Users browsing this thread: 4 Guest(s)