Have just fitted my new Glanze boring bar into my new tool holder. After more years than I care to remember I am upgrading to Quickchange Indexble tooling.
Am I mad or is the Glanze boring bar really down turned by 15 degrees?
As it has flats machined on it I assume it goes into a normal toolholder. If it was rounf I would put in a vee grooved holder and set the rake as I wanted!
Me mucho confuso
See photo
Am I mad or is the Glanze boring bar really down turned by 15 degrees?
As it has flats machined on it I assume it goes into a normal toolholder. If it was rounf I would put in a vee grooved holder and set the rake as I wanted!
Me mucho confuso
See photo
Will_D, proud to be a member of MetalworkingFun Forum since Aug 2014.