08-17-2014, 12:31 PM
(08-16-2014, 10:23 PM)PixMan Wrote: That wall thickness in aluminum is not going to be sufficient for a set screw of any significant size. You would be advised to TIG weld a boss in each location where you need a set screw and then tap it with an "STI" (screw thread insert) tap, then fit a Helicoil or Keen-sert steel thread insert.Ken, I somehow doubt if the term "setscrew" is being used as we know it. Are you familiar with the type of extrusions she's talking about.
EdK , is there some way you can consolidate Marci's posts so there can be some continuity of reference?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.