08-16-2014, 02:20 PM
The Spirit of St. Louis was done with angle grinders and wire wheels.
A guide to keep you inline is very helpful, I used a small fine wire cup in my drill press, playing with jeweling on this vfd cover. It was a old scratched up piece so this hid the them.
A guide to keep you inline is very helpful, I used a small fine wire cup in my drill press, playing with jeweling on this vfd cover. It was a old scratched up piece so this hid the them.
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.