08-16-2014, 10:48 AM
Just Google "Engine Turning", "damascening", or "Jeweling", lots of info out there. I have not found any particular speeds, most instructions call for experimenting on a scrap piece. I found folks using wire brushes, wood dowels, pencil erasers, scothbrite pads, valve grinding compound, felt pads and comertially made tools from Eastwood. One fella uses Craftex pads.
HTH.
Chuck
HTH.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.