08-16-2014, 08:58 AM
I would fold a 180degree return on the inside of the panels, it would take the sharp edges off and give the edges a rigid spine.
Bigbadbugga, proud to be a member of MetalworkingFun Forum since Aug 2014.
|
Help sheet metal advice
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
sheet metal advice - by marciklein1969 - 08-16-2014, 08:09 AM
RE: sheet metal advice - by Bigbadbugga - 08-16-2014, 08:58 AM
RE: sheet metal advice - by stevec - 08-16-2014, 12:40 PM
RE: sheet metal advice - by marciklein1969 - 08-16-2014, 01:24 PM
RE: sheet metal advice - by TomG - 08-17-2014, 01:00 PM
RE: sheet metal advice - by stevec - 08-17-2014, 03:15 PM
RE: sheet metal advice - by Dr Stan - 10-10-2014, 10:50 PM
|
Users browsing this thread: 2 Guest(s)