The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] sheet metal advice

Thread Modes
Help sheet metal advice
marciklein1969 Offline
Freshman
**
Posts: 4
Threads: 2
Joined: Aug 2014
Location: fairfield ct
#1
08-16-2014, 08:09 AM (This post was last modified: 08-16-2014, 08:11 AM by marciklein1969.)
I need to make 12.5 x 18.5 inch steel panels that will slide in a channel. they will be powder coated and used for a furniture line. Im not sure if i should do 16 or 18 gauge and if I would need to fold any edges for stability. Any advice?


Attached Files Thumbnail(s)
   
marciklein1969, proud to be a member of MetalworkingFun Forum since Aug 2014.
Reply
Thanks given by:


Messages In This Thread
sheet metal advice - by marciklein1969 - 08-16-2014, 08:09 AM
RE: sheet metal advice - by Bigbadbugga - 08-16-2014, 08:58 AM
RE: sheet metal advice - by stevec - 08-16-2014, 12:40 PM
RE: sheet metal advice - by marciklein1969 - 08-16-2014, 01:24 PM
RE: sheet metal advice - by TomG - 08-17-2014, 01:00 PM
RE: sheet metal advice - by stevec - 08-17-2014, 03:15 PM
RE: sheet metal advice - by Dr Stan - 10-10-2014, 10:50 PM



Users browsing this thread: 1 Guest(s)