The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Engine turning

Thread Modes
Engine turning
ieezitin Offline
Sophmore
***
Posts: 205
Threads: 27
Joined: Jan 2013
Location: Maryland USA
#1
08-16-2014, 08:05 AM
Hello

Does any of you out there have any suggestions on what to use for an engine turning tip/end tool, and any knowledge on speeds of the quill and lubricant.

Thanks in advance

Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Engine turning - by ieezitin - 08-16-2014, 08:05 AM
RE: Engine turning - by chucketn - 08-16-2014, 10:48 AM
RE: Engine turning - by stevec - 08-16-2014, 12:03 PM
RE: Engine turning - by oldgoaly - 08-16-2014, 02:20 PM
RE: Engine turning - by ieezitin - 08-17-2014, 08:45 AM
RE: Engine turning - by stevec - 08-17-2014, 12:22 PM
RE: Engine turning - by Will_D - 08-18-2014, 06:25 PM
RE: Engine turning - by PixMan - 08-18-2014, 07:09 PM



Users browsing this thread: 1 Guest(s)