MetalworkingFun Forum › Machining › How-To's v
Make Yorkshire Pudding Mix

Thread Modes
Make Yorkshire Pudding Mix
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#6
08-14-2014, 05:23 PM
(08-14-2014, 05:12 PM)Micktoon Wrote: John , I hope you did get any Yorkshire pudding mix on that good drill mind Rotfl

Its not so bad getting a bit of oil in the kitchen but no good getting pudding mix in the workshop Yikes


Cheers Mick

I gave the drill a proper clean once I had finished
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
Make Yorkshire Pudding Mix - by doubleboost - 08-14-2014, 04:38 PM
RE: Make Yorkshire Pudding Mix - by krv3000 - 08-14-2014, 04:48 PM
RE: Make Yorkshire Pudding Mix - by Terry S - 08-14-2014, 05:07 PM
RE: Make Yorkshire Pudding Mix - by doubleboost - 08-14-2014, 05:21 PM
RE: Make Yorkshire Pudding Mix - by Micktoon - 08-14-2014, 05:12 PM
RE: Make Yorkshire Pudding Mix - by doubleboost - 08-14-2014, 05:23 PM
RE: Make Yorkshire Pudding Mix - by chucketn - 08-14-2014, 07:39 PM
RE: Make Yorkshire Pudding Mix - by stevec - 08-15-2014, 06:02 AM
RE: Make Yorkshire Pudding Mix - by EdK - 08-15-2014, 06:46 AM
RE: Make Yorkshire Pudding Mix - by Mayhem - 08-14-2014, 08:26 PM
RE: Make Yorkshire Pudding Mix - by kenne - 08-14-2014, 11:06 PM
RE: Make Yorkshire Pudding Mix - by mfletch - 08-15-2014, 12:56 AM
RE: Make Yorkshire Pudding Mix - by chucketn - 08-15-2014, 07:40 AM
RE: Make Yorkshire Pudding Mix - by vtsteam - 08-21-2014, 09:22 AM
RE: Make Yorkshire Pudding Mix - by texx - 08-16-2014, 05:12 PM
RE: Make Yorkshire Pudding Mix - by tackit - 08-20-2014, 10:44 PM
RE: Make Yorkshire Pudding Mix - by stevec - 08-21-2014, 11:15 AM
RE: Make Yorkshire Pudding Mix - by how'sitwork? - 01-26-2015, 02:47 PM



Users browsing this thread: 4 Guest(s)