MetalworkingFun Forum › Machining › Metrology v
Inspecting and comparing parts

Thread Modes
Inspecting and comparing parts
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#9
08-09-2014, 08:29 AM
You're just looking for an excuse to make more chips...

I was under the impression that my mill was circa 1970 but that has never been confirmed by Kondia. Anything is possible though.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Inspecting and comparing parts - by PixMan - 08-07-2014, 10:34 PM
RE: Inspecting and comparing parts - by EdK - 08-08-2014, 08:38 AM
RE: Inspecting and comparing parts - by Mayhem - 08-08-2014, 10:37 AM
RE: Inspecting and comparing parts - by DaveH - 08-08-2014, 12:49 PM
RE: Inspecting and comparing parts - by Mayhem - 08-08-2014, 06:08 PM
RE: Inspecting and comparing parts - by PixMan - 08-08-2014, 07:20 PM
RE: Inspecting and comparing parts - by DaveH - 08-09-2014, 03:43 PM
RE: Inspecting and comparing parts - by Mayhem - 08-09-2014, 12:48 AM
RE: Inspecting and comparing parts - by PixMan - 08-09-2014, 08:14 AM
RE: Inspecting and comparing parts - by Mayhem - 08-09-2014, 08:29 AM
RE: Inspecting and comparing parts - by stevec - 08-09-2014, 07:02 PM



Users browsing this thread: 3 Guest(s)