08-09-2014, 12:48 AM
Ken - I meant that I would plug the tapped holes in the actual head, not the part. That way, I could use a transfer punch to locate the position of the holes in the bracket to the head, drill and tap M6x1.
The conical gear that provides one of the feed directions (cannot recall which) sits against the hub. I think we should shoot for the same dimension on the hub, otherwise the gear may not mesh correctly.
The conical gear that provides one of the feed directions (cannot recall which) sits against the hub. I think we should shoot for the same dimension on the hub, otherwise the gear may not mesh correctly.
Hunting American dentists since 2015.