MetalworkingFun Forum › Machining › Metrology v
Inspecting and comparing parts

Thread Modes
Inspecting and comparing parts
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#5
08-08-2014, 06:08 PM
Sorry - I forgot to mention that I'm happy to plug the holes on the head and then drill new holes and tap to suit the part. This would mean that all that is needed is machining the boss.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Inspecting and comparing parts - by PixMan - 08-07-2014, 10:34 PM
RE: Inspecting and comparing parts - by EdK - 08-08-2014, 08:38 AM
RE: Inspecting and comparing parts - by Mayhem - 08-08-2014, 10:37 AM
RE: Inspecting and comparing parts - by DaveH - 08-08-2014, 12:49 PM
RE: Inspecting and comparing parts - by Mayhem - 08-08-2014, 06:08 PM
RE: Inspecting and comparing parts - by PixMan - 08-08-2014, 07:20 PM
RE: Inspecting and comparing parts - by DaveH - 08-09-2014, 03:43 PM
RE: Inspecting and comparing parts - by Mayhem - 08-09-2014, 12:48 AM
RE: Inspecting and comparing parts - by PixMan - 08-09-2014, 08:14 AM
RE: Inspecting and comparing parts - by Mayhem - 08-09-2014, 08:29 AM
RE: Inspecting and comparing parts - by stevec - 08-09-2014, 07:02 PM



Users browsing this thread: 3 Guest(s)