Coke Forge Build

[RobWilson]

Thanks for the comments Lads

(08-06-2014, 03:57 PM)EdK Wrote: Rob,

What type of welder are you using? Nice job of welding up the sculpture.

Ed

Hi Ed , my welding set up is nothing special just a welder from Machine Mart



It dose what I need of it , had it about 10 years and haven't killed it yet

(08-06-2014, 04:37 PM)Micktoon Wrote: Hi Rob , coming along nicely , I do like to see a robust job getting done , not like the S***E on sale new everywhere these days,there would only be the odd tack weld on the finished job.
I dont think yours will come to much harm if it takes a knock

Cheers Mick

I here you Mick ,,,,,,,,,,,never buy a Doosan forklift the welding on those is very poor , I think they should be re branded as DooDoosan



Well tonight's offerings ,not much but better than nowt , finished off the welding ,ground off the weld flush on the underside of the top flange .



and ground up and rounded off the edge of the top face of the top flange .



Just need to cut a hole into the hearth to fit the fire pot .




Cheers Rob