Let's See Your Shop

[Shawn]

Some photos of my shop in about as clean a state as it gets. The two wooden cabinets are old paper forms cabinets and are full of material and milling accessories.





I love the little Benchmaster horizontal but it really needs a VFD and power feed table.


It's been slow going on the Smart and Brown 1024VSL but this Fall work will commence full tilt again.






Cnc X2 mill to the left of the horizontal


SB7" shaper is at my left elbow in the picture. The back corner is where the power hacksaw, bench grinder, buffers are located, along with a bunch of other junk. The $40 delta drill press is my best deal yet aside from the shaper but that was more of a gift from a machinist giving me a hand getting tooled up.


Shawn