MetalworkingFun Forum › Machinery › Lathes v
Buying sight unseen?

Thread Modes
Buying sight unseen?
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
The following 1 user Likes Hawkeye's post:
Shawn (08-06-2014)
#9
08-05-2014, 08:38 PM
Hey, Shawn. Where is it located? 3 hours from you could be farther from here, but it could also be closer to here. If it is, I could possibly scope it out for you.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Buying sight unseen? - by Shawn - 08-05-2014, 12:32 PM
RE: Buying sight unseen? - by stevec - 08-05-2014, 02:14 PM
RE: Buying sight unseen? - by 12345678910 - 08-05-2014, 02:14 PM
RE: Buying sight unseen? - by stevec - 08-05-2014, 02:31 PM
RE: Buying sight unseen? - by PixMan - 08-05-2014, 02:24 PM
RE: Buying sight unseen? - by Shawn - 08-05-2014, 03:15 PM
RE: Buying sight unseen? - by f350ca - 08-05-2014, 04:45 PM
RE: Buying sight unseen? - by stevec - 08-05-2014, 06:11 PM
RE: Buying sight unseen? - by Hawkeye - 08-05-2014, 08:38 PM
RE: Buying sight unseen? - by Shawn - 08-06-2014, 01:20 AM
RE: Buying sight unseen? - by kenne - 08-05-2014, 09:23 PM
RE: Buying sight unseen? - by Mayhem - 08-06-2014, 08:01 AM
RE: Buying sight unseen? - by stevec - 08-06-2014, 08:56 AM
RE: Buying sight unseen? - by Hawkeye - 08-06-2014, 08:24 PM
RE: Buying sight unseen? - by Shawn - 08-08-2014, 12:17 AM
RE: Buying sight unseen? - by Hawkeye - 08-08-2014, 09:33 PM



Users browsing this thread: 3 Guest(s)