The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › Projects v
Simple project, dimple die

Thread Modes
Simple project, dimple die
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
The following 1 user Likes Shawn's post:
oldgoaly (08-15-2014)
#1
08-05-2014, 03:23 PM
I built this dimple die from a couple pieces of scrap aluminium I had. I cut both angles to 45 degrees, took about 20-30 minutes at the lathe and works great on the thin gauge aluminum sheet I needed it for. I plan to make a few more from 4140 and harden them but I think the aluminium will stand up to a few hundred holes or more.

[Image: image.jpg]
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by: oldgoaly


Messages In This Thread
Simple project, dimple die - by Shawn - 08-05-2014, 03:23 PM
RE: Simple project, dimple die - by awemawson - 08-05-2014, 03:49 PM
RE: Simple project, dimple die - by Shawn - 08-05-2014, 04:11 PM
RE: Simple project, dimple die - by stevec - 08-05-2014, 06:14 PM
RE: Simple project, dimple die - by Shawn - 08-05-2014, 10:11 PM



Users browsing this thread: 1 Guest(s)