07-25-2014, 04:38 PM
I'm quite sure you will have enough air for a coke fueled furnace with one of these blowers.
I got rid of the flex hose and used a short piece of 4" PVC to hook it up to the burner for a test run and to check the air pressure in the burner body which was about 6" WC. I then did a timed burn using preheated waste oil an was able to lower the oil level in my 8 inch diameter fuel tank by 2 inches in 30 minutes using a syphon nozzle an gravity feed.
Here's link the it running when I used compressed air to blow out the oil line when I shut it down.
http://vid1222.photobucket.com/albums/dd...462078.mp4
I got rid of the flex hose and used a short piece of 4" PVC to hook it up to the burner for a test run and to check the air pressure in the burner body which was about 6" WC. I then did a timed burn using preheated waste oil an was able to lower the oil level in my 8 inch diameter fuel tank by 2 inches in 30 minutes using a syphon nozzle an gravity feed.
Here's link the it running when I used compressed air to blow out the oil line when I shut it down.
http://vid1222.photobucket.com/albums/dd...462078.mp4
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!