I was just poking around on the PM forum and was reminded by a thread there that I have some yet-to-be-used tooling for my surface grinder. Among those tools is a Phase II (brand) Chinese made radius & angle dresser.
I picked up off the local Craigslist for $35 a little over two years ago and have yet to need to use it. It's there when I need it, though I suppose now that I dragged it out of the cabinet I should clean the original Cosmolene off and give it a try.
![[Image: IMG_2383-r_zps04e66aad.jpg]](http://img.photobucket.com/albums/v466/kenm10759/Dads%20shop/IMG_2383-r_zps04e66aad.jpg)
Now thinking about it, there's a few other grinder-specific tools I have and rarely use, so here's another photo. These are pass-thru magnetic parallels and vee blocks. Some found locally, most from eBay for cheap. I don't think I spent $50 for the lot. I've used a couple of the parallels once or twice, that's about it.
![[Image: IMG_0301-r.jpg]](http://img.photobucket.com/albums/v466/kenm10759/Dads%20shop/IMG_0301-r.jpg)
What do you guys have?
I picked up off the local Craigslist for $35 a little over two years ago and have yet to need to use it. It's there when I need it, though I suppose now that I dragged it out of the cabinet I should clean the original Cosmolene off and give it a try.
Now thinking about it, there's a few other grinder-specific tools I have and rarely use, so here's another photo. These are pass-thru magnetic parallels and vee blocks. Some found locally, most from eBay for cheap. I don't think I spent $50 for the lot. I've used a couple of the parallels once or twice, that's about it.
What do you guys have?