07-19-2014, 10:14 PM
Hi Ken,
I haven't checked it using the gauge block method you suggested. I did check it with the DRO and it's within less than .001" but that could be just because I can't turn the dial from zero to zero that accurately. I will do the measurement using your suggested method tomorrow. I may have a question or two about that method but I'll read through it again to make sure it's clear to me.
Ed
I haven't checked it using the gauge block method you suggested. I did check it with the DRO and it's within less than .001" but that could be just because I can't turn the dial from zero to zero that accurately. I will do the measurement using your suggested method tomorrow. I may have a question or two about that method but I'll read through it again to make sure it's clear to me.
Ed