Using Harold Hall’s Deluxe Grinding Table and jigs

[chucketn]

I will do that(post Pictures) in the morning when I get started again. I did review the chapter in HH's book and found a picture of how he set up the block to mill one of the V notches. I wish I'd seen and paid attention to it sooner! Sometimes I get too far ahead of myself!
As usually happens with me, I get messed up because I failed to read the whole story, and ask for help. Then while waiting for replies I re-re-re-read the instructing article and see what I either skipped over or what just didn't register in my pea sized brain the first time...
I am adapting metric plans to inch dimentioned material, though I do have a few metric taps and fewer metric dies...

Chuck