MetalworkingFun Forum › Machining › General Metalworking Discussion v
Babit Bearings

Thread Modes
Babit Bearings
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#10
07-08-2014, 03:16 PM
Greg, I think Terry's got a point. What would the original alligator used for bearings? I'd bet on maple.
Easy to make and easy to replace on a regular maintenance basis.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Babit Bearings - by f350ca - 07-07-2014, 10:38 PM
RE: Babit Bearings - by PixMan - 07-07-2014, 11:19 PM
RE: Babit Bearings - by ETC57 - 07-07-2014, 11:43 PM
RE: Babit Bearings - by Mayhem - 07-08-2014, 05:06 AM
RE: Babit Bearings - by stevec - 07-08-2014, 05:42 AM
RE: Babit Bearings - by f350ca - 07-08-2014, 08:20 AM
RE: Babit Bearings - by Terry S - 07-08-2014, 08:29 AM
RE: Babit Bearings - by f350ca - 07-08-2014, 08:53 AM
RE: Babit Bearings - by Terry S - 07-08-2014, 02:26 PM
RE: Babit Bearings - by stevec - 07-08-2014, 03:16 PM
RE: Babit Bearings - by f350ca - 07-08-2014, 04:54 PM
RE: Babit Bearings - by stevec - 07-08-2014, 05:33 PM
RE: Babit Bearings - by f350ca - 07-08-2014, 07:03 PM
RE: Babit Bearings - by vtsteam - 08-27-2014, 09:58 PM
RE: Babit Bearings - by f350ca - 08-27-2014, 10:40 PM
RE: Babit Bearings - by AllanC - 08-28-2014, 03:20 AM
RE: Babit Bearings - by stevec - 08-28-2014, 03:56 AM
RE: Babit Bearings - by vtsteam - 08-28-2014, 06:25 AM



Users browsing this thread: 2 Guest(s)