|
Mill an open slot in thin material.
|
07-08-2014, 02:20 PM
(07-08-2014, 11:12 AM)TomG Wrote: if you only need one, rotate the part 90º and place a piece of scrap between the jaw and the part to mill into.That is the good machining way to do it, because one is machining against the vice jaw. And if you can always try to machine against the fixed jaw.  DaveH |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mill an open slot in thin material. - by DaveH - 07-07-2014, 01:39 PM
RE: Mill an open slot in thin material. - by EdK - 07-07-2014, 06:15 PM
RE: Mill an open slot in thin material. - by DaveH - 07-07-2014, 07:24 PM
RE: Mill an open slot in thin material. - by DaveH - 07-07-2014, 07:58 PM
RE: Mill an open slot in thin material. - by EdK - 07-07-2014, 08:19 PM
RE: Mill an open slot in thin material. - by awemawson - 07-08-2014, 02:21 AM
RE: Mill an open slot in thin material. - by stevec - 07-08-2014, 05:47 AM
RE: Mill an open slot in thin material. - by TomG - 07-08-2014, 11:12 AM
RE: Mill an open slot in thin material. - by DaveH - 07-08-2014, 02:20 PM
RE: Mill an open slot in thin material. - by Dr Stan - 11-03-2014, 11:14 AM
RE: Mill an open slot in thin material. - by EdK - 11-03-2014, 05:13 PM
|
