MetalworkingFun Forum › Machining › How-To's v
Mill an open slot in thin material.

Thread Modes
Mill an open slot in thin material.
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
DaveH (07-08-2014)
#8
07-08-2014, 11:12 AM
That's the way to do it Dave if you need two parts. if you only need one, rotate the part 90º and place a piece of scrap between the jaw and the part to mill into.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: DaveH


Messages In This Thread
Mill an open slot in thin material. - by DaveH - 07-07-2014, 01:39 PM
RE: Mill an open slot in thin material. - by EdK - 07-07-2014, 06:15 PM
RE: Mill an open slot in thin material. - by EdK - 07-07-2014, 08:19 PM
RE: Mill an open slot in thin material. - by TomG - 07-08-2014, 11:12 AM
RE: Mill an open slot in thin material. - by EdK - 11-03-2014, 05:13 PM



Users browsing this thread: 1 Guest(s)