07-08-2014, 05:47 AM
'Round here it depends where you source your "keystock" as to what type/quality of steel you get
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
Mill an open slot in thin material.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mill an open slot in thin material. - by DaveH - 07-07-2014, 01:39 PM
RE: Mill an open slot in thin material. - by EdK - 07-07-2014, 06:15 PM
RE: Mill an open slot in thin material. - by DaveH - 07-07-2014, 07:24 PM
RE: Mill an open slot in thin material. - by DaveH - 07-07-2014, 07:58 PM
RE: Mill an open slot in thin material. - by EdK - 07-07-2014, 08:19 PM
RE: Mill an open slot in thin material. - by awemawson - 07-08-2014, 02:21 AM
RE: Mill an open slot in thin material. - by stevec - 07-08-2014, 05:47 AM
RE: Mill an open slot in thin material. - by TomG - 07-08-2014, 11:12 AM
RE: Mill an open slot in thin material. - by DaveH - 07-08-2014, 02:20 PM
RE: Mill an open slot in thin material. - by Dr Stan - 11-03-2014, 11:14 AM
RE: Mill an open slot in thin material. - by EdK - 11-03-2014, 05:13 PM
|
Users browsing this thread: 3 Guest(s)