07-06-2014, 01:23 PM
I would go with ED,s instinct , from what I have seen and no about the Chester machines ( I own a 626 MILL and have seen others) is that they are a tab ruff and fit were they touch .
An old chap I no has that very mill your looking at from Warco and has only had one bit of bother with it and that was down to him aggressively fly cutting a job and bust a gear .
Regards Rob
An old chap I no has that very mill your looking at from Warco and has only had one bit of bother with it and that was down to him aggressively fly cutting a job and bust a gear .
Regards Rob