07-05-2014, 12:20 PM
Made a 'cup' that goes on top of the top die, it it held in place by 5mm c/s machine screw. According to Swag it helps to keep it centered.
I see my photos are up to the same rubbish as normal
There are two parts both painted black (if I had taken a proper photo I wouldn't have to write all this) the bottom part is the 'cup' the other part (smaller dia.) is fixed to the hydraulic press and presses inside the 'cup' to force the top die down.
DaveH
I see my photos are up to the same rubbish as normal
There are two parts both painted black (if I had taken a proper photo I wouldn't have to write all this) the bottom part is the 'cup' the other part (smaller dia.) is fixed to the hydraulic press and presses inside the 'cup' to force the top die down.
DaveH