Kondia FV-1 Head disassembly

[Mayhem]

Thanks Ken. I'm really enjoying seeing the progress.

(07-04-2014, 09:23 PM)PixMan Wrote: ...One question for you, Darren: On the print there's a 10mm wide slot at a 45º angle with 4mm corner radii, from the 38mm counterbore through the wall of the 25mm radius and at the depth of the 38mm counterbore. I think it's just there to give you a place to pry the round black ring off when you need to take it apart. Since I don't have either an 8mm nor 5/16" ball mill, would you be OK with me using a 1/4" ball mill I have? That would leave about a .144" wide flat at the bottom rather than a 2mm one. This OK?

Let me take a look at the parts and the drawing and get back to you. I've just installed the quill skirt that I had made and I will probably be able to assemble this part to double check everything. I don't think the BP mills have that feature either but I'm unsure if Kondia has it there for a reason. Access to a screw perhaps?

I'll confirm...