you may be able to put it in the mill spindle and lock the break if it has one, then like DaveH said use a strap wrench to break the thread loose on the drill chuck body by putting it around the large knurled area, once loosened remove from the mill and finish unscrewing while holding it over a large towel or in a pan as there is about 30 small steel ball bearings in it, AND you don't want to loose one of them,
DA
Check the manufactures website they probably have instructions.
DA
DA
Check the manufactures website they probably have instructions.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!