The 1/4-40 screw is the fuel adjusting scew for a model airplaine engine. I don't have the plans in front of me (on vacation) but will look it up and post it when I get home. I do remember the designer sells the plans and is from PA. He also sells castings for various tools and lathe accessories.
The friend I made it for has used it sucessfully and it didn't break. He would have made it himself but lost track of his change gears in a move.
Our next project will be a dividing head, and cast aluminum blanks to make a set of change gears for his lathe.
Chuck
The friend I made it for has used it sucessfully and it didn't break. He would have made it himself but lost track of his change gears in a move.
Our next project will be a dividing head, and cast aluminum blanks to make a set of change gears for his lathe.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.