(06-29-2014, 10:11 AM)DaveH Wrote: Thanks Willie,
Welded it - not a pretty site, I'll clean them up then they won't look too bad
DaveH
Before you make them pretty Dave, I would consider grinding off that center bead on the right side and give it a "do-over". Other than that I think you are good to go without seeing the other side.
I'm assuming your are going to mill off the excess from the bottom of the guides? Just be careful of those weld beads because they are probably going to be in carbide or grinding wheel territory in terms of hardness.
It won't be long now, and you'll be doing your signature dance again.
Willie