The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
what's the best way to ream out 1 1/16 holes to 1 1/4

Thread Modes
what's the best way to ream out 1 1/16 holes to 1 1/4
tackit Offline
Sophmore
***
Posts: 125
Threads: 18
Joined: May 2014
Location: IN
#1
06-28-2014, 05:12 PM
Guys I want to ream the platen supporting holes in my hydraulic press out to 1 1/4" from 1 1/16". Will bridge reamers work? If so what progressive sizes should I buy to do the job properly, the steel is 1" thick, Thank you, Tackit


Attached Files Thumbnail(s)
           

.jpg   holesdrilled_zpsd84c049e[1].jpg (Size: 80.46 KB / Downloads: 119)
tackit, proud to be a member of MetalworkingFun Forum since May 2014.
Reply
Thanks given by:


Messages In This Thread
what's the best way to ream out 1 1/16 holes to 1 1/4 - by tackit - 06-28-2014, 05:12 PM



Users browsing this thread: 2 Guest(s)