Lathe Cross Slide Problem

[EdK]

(06-23-2014, 06:06 PM)PixMan Wrote: Perfect way to do it! And yes, I did notice it went a little out-of-flat there after slitting it. Good of you to get it right, hope it fits when done.

Oh good!

I held off doing anything tonight just in case I was way off base in the way I did it the first time. While setting up the mill with the vise and end mill in preparation, I cut my finger on the end mill and decided I better put it off until tomorrow evening. It took the wind out of my sails (it doesn't take much these days).

Ed