06-22-2014, 01:33 PM
High power.
i would imagine to save money on material when they cast it, other than that i dont really know.
Pix
the spindle has a spline on one end and a tab stamping on the other, for me to make this spindle from scratch would take allot of time, i am chopping off both ends and will make a slug for the middle.
Im not sure this is going to work, i may weaken it but i am going to try, the spindle housings did not really take that long, I probably will make two more sets and replace them as they are better constructed than the originals.
weather this works or not i am going to order another complete spindle housing any way as i don't have time to keep investing in this project.
Will have more pics later..
Anthony.
i would imagine to save money on material when they cast it, other than that i dont really know.
Pix
the spindle has a spline on one end and a tab stamping on the other, for me to make this spindle from scratch would take allot of time, i am chopping off both ends and will make a slug for the middle.
Im not sure this is going to work, i may weaken it but i am going to try, the spindle housings did not really take that long, I probably will make two more sets and replace them as they are better constructed than the originals.
weather this works or not i am going to order another complete spindle housing any way as i don't have time to keep investing in this project.
Will have more pics later..
Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.