06-20-2014, 11:27 AM
(06-20-2014, 10:57 AM)Highpower Wrote: Dave, do you by chance have an indexing head w/4 jaw chuck?
Or you could put your woodworking skills to use and build a v-block / fixture from lumber to hold the part at the proper angle and clamp the whole works to the table.
I have an indexing head with a 4 jaw chuck. I was thinking about using the tilting vice one side and using a rotary table to hold the other end.
I didn't really want to make any fixtures - being the lazy bastard I am
I'm just a bit concerned about the length and it flapping about in the breeze.
A couple of tilting tables would be nice
which I haven't got 
DaveH