The top die. This is 4" high x 16" long x .75" thick, and on one of the 16" long sides I have to machine a double chamfer 60 or 70deg (included) point.
Normally with long pieces I use two vices, however these two vices do not tilt. I have another vice that does tilt but only the one vice.
Anyone have an idea how I should do this?
DaveH
Normally with long pieces I use two vices, however these two vices do not tilt. I have another vice that does tilt but only the one vice.
Anyone have an idea how I should do this?
DaveH