|
Bench grinder setups
|
06-12-2014, 03:06 PM
I meant the diamond was for the carbide. will it handle roughing out? For example, I want to grind a round carbide tool for use in a tangential tool I'm making. It has a 30° jig I use for the square HSS bits also.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Bench grinder setups - by chucketn - 06-12-2014, 10:04 AM
RE: Bench grinder setups - by Arbalest - 06-12-2014, 01:09 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 01:22 PM
RE: Bench grinder setups - by f350ca - 06-12-2014, 01:47 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 03:11 PM
RE: Bench grinder setups - by chucketn - 06-12-2014, 03:06 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 03:16 PM
RE: Bench grinder setups - by EdK - 06-12-2014, 04:10 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 08:03 PM
RE: Bench grinder setups - by Arbalest - 06-13-2014, 03:02 AM
RE: Bench grinder setups - by PixMan - 06-13-2014, 05:16 AM
RE: Bench grinder setups - by arvidj - 06-13-2014, 08:32 AM
RE: Bench grinder setups - by DaveH - 06-13-2014, 09:06 AM
RE: Bench grinder setups - by chucketn - 06-13-2014, 09:09 AM
RE: Bench grinder setups - by arvidj - 06-13-2014, 09:20 AM
RE: Bench grinder setups - by chucketn - 06-13-2014, 10:41 AM
RE: Bench grinder setups - by ziggar - 06-13-2014, 04:57 PM
|
