Bench grinder setups
#3
I use aluminum oxide for HSS and reserve the diamond wheel for carbide. I've got a brand new silicon carbide wheel sitting on the shelf. It was used one time and that was enough for me. A diamond wheel works much, much better on carbide. If you have the funds and the space for them, having multiple grinders set up makes things go a lot quicker but it's not a necessity. I use a belt sander for most of my roughing.
Willie
Reply
Thanks given by:


Messages In This Thread
Bench grinder setups - by chucketn - 06-12-2014, 10:04 AM
RE: Bench grinder setups - by Arbalest - 06-12-2014, 01:09 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 01:22 PM
RE: Bench grinder setups - by f350ca - 06-12-2014, 01:47 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 03:11 PM
RE: Bench grinder setups - by chucketn - 06-12-2014, 03:06 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 03:16 PM
RE: Bench grinder setups - by EdK - 06-12-2014, 04:10 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 08:03 PM
RE: Bench grinder setups - by Arbalest - 06-13-2014, 03:02 AM
RE: Bench grinder setups - by PixMan - 06-13-2014, 05:16 AM
RE: Bench grinder setups - by arvidj - 06-13-2014, 08:32 AM
RE: Bench grinder setups - by DaveH - 06-13-2014, 09:06 AM
RE: Bench grinder setups - by chucketn - 06-13-2014, 09:09 AM
RE: Bench grinder setups - by arvidj - 06-13-2014, 09:20 AM
RE: Bench grinder setups - by chucketn - 06-13-2014, 10:41 AM
RE: Bench grinder setups - by ziggar - 06-13-2014, 04:57 PM



Users browsing this thread: 5 Guest(s)