Bench grinder setups
#2
1/2" wheels on a standard grinder are far too narrow for me, I went for 1" wide.
I would have thought a diamond cup wheel would suffice for sharpening most stuff including carbide wouldn't it?
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
Bench grinder setups - by chucketn - 06-12-2014, 10:04 AM
RE: Bench grinder setups - by Arbalest - 06-12-2014, 01:09 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 01:22 PM
RE: Bench grinder setups - by f350ca - 06-12-2014, 01:47 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 03:11 PM
RE: Bench grinder setups - by chucketn - 06-12-2014, 03:06 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 03:16 PM
RE: Bench grinder setups - by EdK - 06-12-2014, 04:10 PM
RE: Bench grinder setups - by Highpower - 06-12-2014, 08:03 PM
RE: Bench grinder setups - by Arbalest - 06-13-2014, 03:02 AM
RE: Bench grinder setups - by PixMan - 06-13-2014, 05:16 AM
RE: Bench grinder setups - by arvidj - 06-13-2014, 08:32 AM
RE: Bench grinder setups - by DaveH - 06-13-2014, 09:06 AM
RE: Bench grinder setups - by chucketn - 06-13-2014, 09:09 AM
RE: Bench grinder setups - by arvidj - 06-13-2014, 09:20 AM
RE: Bench grinder setups - by chucketn - 06-13-2014, 10:41 AM
RE: Bench grinder setups - by ziggar - 06-13-2014, 04:57 PM



Users browsing this thread: 1 Guest(s)