|
Bandsaw Blade Repair Jig
|
06-04-2014, 07:50 AM
Guys I see the blade slot but how does Tom cut the slot to an even depth across the jig? The slot just a little off would cause the blade to grind at an angle. My blade is 1" wide so I would think I would need a tight slot 1/2" deep to get a even 20 degree grind on both sides..
tackit, proud to be a member of MetalworkingFun Forum since May 2014.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Bandsaw Blade Repair Jig - by tackit - 06-03-2014, 08:05 PM
RE: Bandsaw Blade Repair Jig - by Micktoon - 06-04-2014, 03:19 AM
RE: Bandsaw Blade Repair Jig - by tackit - 06-04-2014, 05:16 AM
RE: Bandsaw Blade Repair Jig - by stevec - 06-04-2014, 05:45 AM
RE: Bandsaw Blade Repair Jig - by chucketn - 06-04-2014, 06:39 AM
RE: Bandsaw Blade Repair Jig - by EdK - 06-04-2014, 12:40 PM
RE: Bandsaw Blade Repair Jig - by tackit - 06-04-2014, 07:50 AM
RE: Bandsaw Blade Repair Jig - by Mayhem - 06-04-2014, 07:58 AM
RE: Bandsaw Blade Repair Jig - by TomG - 06-04-2014, 08:21 AM
RE: Bandsaw Blade Repair Jig - by tackit - 06-04-2014, 09:16 AM
RE: Bandsaw Blade Repair Jig - by TomG - 06-04-2014, 09:26 AM
RE: Bandsaw Blade Repair Jig - by tackit - 06-04-2014, 08:27 PM
RE: Bandsaw Blade Repair Jig - by tackit - 06-25-2014, 11:51 PM
RE: Bandsaw Blade Repair Jig - by stevec - 06-26-2014, 07:32 AM
RE: Bandsaw Blade Repair Jig - by tackit - 06-26-2014, 08:06 AM
RE: Bandsaw Blade Repair Jig - by stevec - 06-26-2014, 08:46 AM
RE: Bandsaw Blade Repair Jig - by tackit - 06-26-2014, 09:29 AM
RE: Bandsaw Blade Repair Jig - by kenne - 06-26-2014, 11:25 AM
|
