06-01-2014, 08:07 PM
Hey Darren (and anyone else who can help),
I looked over the print for the quill feed engagement part as I was to start making it yesterday. I found that I need some help with extrapolating some dimensions, but I no longer have a working copy of AutoCad2000 to do it.
What I need is the X-Y coordinate values for the angles coming off the 25mm radius, out to the 60mm width. Kondia clearly used a casting that would have had those dimensions, so we'll have to figure them out. Got any ideas?
Other that that, I've decided to run up to BTS-Patriot Steels in Dover NH to get a couple of pieces of 4142 pre-treated stock to make the part. Of course I only need one piece, but you know Murphy's Law, subchapter C, paragraph 5, "If you have a spare piece of stock you won't need it, it you don't have a spare you WILL need it."
I looked over the print for the quill feed engagement part as I was to start making it yesterday. I found that I need some help with extrapolating some dimensions, but I no longer have a working copy of AutoCad2000 to do it.
What I need is the X-Y coordinate values for the angles coming off the 25mm radius, out to the 60mm width. Kondia clearly used a casting that would have had those dimensions, so we'll have to figure them out. Got any ideas?
Other that that, I've decided to run up to BTS-Patriot Steels in Dover NH to get a couple of pieces of 4142 pre-treated stock to make the part. Of course I only need one piece, but you know Murphy's Law, subchapter C, paragraph 5, "If you have a spare piece of stock you won't need it, it you don't have a spare you WILL need it."