|
custom tap
|
05-29-2014, 07:57 PM
I've been thinking about this whole "that's good enough" and would like to bring my skill level up a notch to the point of being able to machine something to a known spec rather than to match one piece to another piece. This is purely a hobby for me so I can afford the time necessary to take the time to do that. Pride in workmanship rather than that's good enough. Sorry for the ramblings.
 Ed |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
custom tap - by chucketn - 05-29-2014, 12:03 PM
RE: custom tap - by PixMan - 05-29-2014, 02:20 PM
RE: custom tap - by chucketn - 05-29-2014, 05:22 PM
RE: custom tap - by f350ca - 05-29-2014, 07:22 PM
RE: custom tap - by PixMan - 05-29-2014, 07:25 PM
RE: custom tap - by Mayhem - 05-29-2014, 07:31 PM
RE: custom tap - by PixMan - 05-29-2014, 07:47 PM
RE: custom tap - by EdK - 05-29-2014, 07:57 PM
RE: custom tap - by Highpower - 05-29-2014, 08:35 PM
RE: custom tap - by EdK - 05-29-2014, 08:52 PM
RE: custom tap - by chucketn - 05-29-2014, 08:32 PM
RE: custom tap - by EdK - 05-29-2014, 08:48 PM
RE: custom tap - by kenne - 06-30-2014, 05:01 PM
RE: custom tap - by EdK - 06-30-2014, 07:10 PM
RE: custom tap - by Mayhem - 05-30-2014, 12:39 AM
RE: custom tap - by chucketn - 05-30-2014, 07:09 AM
RE: custom tap - by TomG - 05-30-2014, 08:13 PM
RE: custom tap - by chucketn - 05-31-2014, 09:04 AM
RE: custom tap - by Sunset Machine - 06-01-2014, 08:15 AM
RE: custom tap - by kenne - 06-29-2014, 12:05 AM
RE: custom tap - by chucketn - 06-29-2014, 05:49 PM
RE: custom tap - by stevec - 06-30-2014, 06:38 AM
RE: custom tap - by chucketn - 06-30-2014, 11:39 AM
RE: custom tap - by Arbalest - 06-30-2014, 05:38 PM
|
