05-29-2014, 07:32 PM
You need a few more dimensions. You had shown a photo of the underside of the cross slide, and I believe you had milled a rectangular landing spot where you will fasten the nut.
What is the thickness between the top of the cross slide and the surface you milled? Add that thickness to the 0.926" that I made the nut, and you have the "?2" dimension to compare to "?1".
What is the thickness between the top of the cross slide and the surface you milled? Add that thickness to the 0.926" that I made the nut, and you have the "?2" dimension to compare to "?1".